These methods are to be used as a basis for comparison of absorbents in a consistent manner.
These tests are not appropriate for adsorbent materials which are covered in Test Method F726.
These methods are not useful for a comparison of absorbents with adsorbents, even though all absorbents exhibit adsorbent properties. Both types of materials have prime areas of utility.
These methods may not list all the safety and disposal options necessary for safe ultimate disposal of used sorbent material into the environment. Federal, state, and local regulatory rules must be followed.
1.1 These test methods cover the development of laboratory test data which describe the performance of absorbent materials used to remove oils and other compatible fluids from water.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. (For a specific warning statement see 10.4.)
Copyright ©2024 All Rights Reserved