ASTM E1237-93(2009)
Standard Guide for Installing Bonded Resistance Strain Gages
- Standard No.
- ASTM E1237-93(2009)
- Release Date
- 1993
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM E1237-93(2014)
- Latest
- ASTM E1237-20
- Scope
Methods and procedures used in installing bonded resistance strain gages can have significant effects upon the performance of those sensors. Optimum and reproducible detection of surface deformation requires appropriate and consistent surface preparation, mounting procedures, and verification techniques.
1.1 This guide provides guidelines for installing bonded resistance strain gages. It is not intended to be used for bulk or diffused semiconductor gages. This document pertains only to adhesively bonded strain gages.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM E1237-93(2009) Referenced Document
- ASTM E251 Standard Test Methods for Performance Characteristics of Metallic Bonded Resistance Strain Gages
ASTM E1237-93(2009) history
- 2020 ASTM E1237-20 Standard Guide for Installing Bonded Resistance Strain Gages
- 1993 ASTM E1237-93(2014) Standard Guide for Installing Bonded Resistance Strain Gages
- 1993 ASTM E1237-93(2009) Standard Guide for Installing Bonded Resistance Strain Gages
- 1993 ASTM E1237-93(2003) Standard Guide for Installing Bonded Resistance Strain Gages
- 1998 ASTM E1237-93(1998) Standard Guide for Installing Bonded Resistance Strain Gages
