BS EN ISO 527-5:2009
Plastics - Determination of tensile properties - Part 5:Test conditions for unidirectional fibre-reinforced plastic composites

Standard No.

BS EN ISO 527-5:2009

Release Date

2009

Published By

British Standards Institution (BSI)

Status

Be replaced 2021-12

Replace By

BS EN ISO 527-5:2021

Latest

BS EN ISO 527-5:2021

Replace

BS EN ISO 527-5:1997

Scope

1.1 This part of ISO 527 specifies the test conditions for the determination of the tensile properties of unidirectional fibre-reinforced plastic composites, based upon the general principles given in Part 1. 1.2 See ISO 527-1:1993, Subclause 1.2. 1.3 The test method is suitable for all polymer matrix systems reinforced with unidirectional fibres and which meet the requirements, including failure mode, set out in this part of ISO 527. The method is suitable for composites with either thermoplastic or thermosetting matrices, including preimpregnated materials (prepregs). The reinforcements covered include carbon fibres, glass fibres, aramid fibres and other similar fibres. The reinforcement geometries covered include unidirectional (i.e. completely aligned) fibres and rovings and unidirectional fabrics and tapes. The method is not normally suitable for multidirectional materials composed of several unidirectional layers at different angles (see ISO 527-4). 1.4 The method is performed using one of two different types of test specimen, depending on the direction of the applied stress relative to the fibre direction (see Clause 6). 1.5 See ISO 527-1:1993, Subclause 1.5.

BS EN ISO 527-5:2009 Referenced Document

• ISO 1268 Plastics; Preparation of glass fibre reinforced, resin bonded, low-pressure laminated plates or panels for test purposes
• ISO 2818 Plastics — Preparation of test specimens by machining*， 2018-12-13 Update
• ISO 3534-1 Statistics — Vocabulary and symbols — Part 1: General statistical terms and terms used in probability
• ISO 527-1:1993 Plastics; determination of tensile properties; part 1: general principles
• ISO 527-4 Plastics — Determination of tensile properties — Part 4: Test conditions for isotropic and orthotropic fibre-reinforced plastic composites*， 2023-03-24 Update

BS EN ISO 527-5:2009 history

• 2021 BS EN ISO 527-5:2021 Plastics. Determination of tensile properties. Test conditions for unidirectional fibre-reinforced plastic composites
• 2009 BS EN ISO 527-5:2009 Plastics - Determination of tensile properties - Part 5:Test conditions for unidirectional fibre-reinforced plastic composites
• 1997 BS EN ISO 527-5:1997 Plastics - Determination of tensile properties - Test conditions for unidirectional fibre-reinforced plastic composites