ASTM E1955-04(2009)
Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM E 390 Reference Radiographs

Standard No.

ASTM E1955-04(2009)

Release Date

2004

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM E1955-04(2014)

Latest

ASTM E1955-20

Scope

This standard can be used to establish acceptance criteria for weld soundness based on the procedures and reference radiographs of ASTM E 390. The grades specified in this standard, while applicable for general examination use for the materials and thicknesses indicated, may not be suitable for all applications.

1.1 This standard covers requirements for radiographic examination for soundness of welds in fabricated steel by comparison to selected severity levels of Reference Radiographs E 390, Vol II. The base material varies from greater than 0.25 to 3 in. (6.4–76 mm) inclusive in thickness. Volume II is applicable. This standard is not suitable for shipyard use.

Note 18212;This standard was adopted to replace Mil-Std. 1264-B entitled “Radiographic Inspection For Soundness of Welds In Steel By Comparison To Graded ASTM E 390 Reference Radiographs,” dated 18 January, 1989. This standard is intended to be used for the same applications as the document which it replaced. Users should carefully review its requirements when considering the standard''s use for new and/or different applications.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM E1955-04(2009) history

• 2020 ASTM E1955-20 Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM Reference Radiographs
• 2004 ASTM E1955-04(2014) Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM Reference Radiographs
• 2004 ASTM E1955-04(2009) Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM E 390 Reference Radiographs
• 2004 ASTM E1955-04 Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM E 390 Reference Radiographs
• 1998 ASTM E1955-98 Standard Radiographic Examination for Soundness of Welds in Steel by Comparison to Graded ASTM E 390 Reference Radiographs