ASTM D7471-09
Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials

Standard No.

ASTM D7471-09

Release Date

2009

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D7471-09(2014)

Latest

ASTM D7471-19

Scope

1.1 This specification covers copolymers of chlorotrifluoroethylene, perfluoroalkoxy, and tetrafluoroethylene and are suitable for extrusion, compression, and injection molding.

1.2 This specification does not cover blended materials and does not cover recycled materials.

1.3 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 18212;There is no known ISO equivalent to this standard.

ASTM D7471-09 history

• 2019 ASTM D7471-19 Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials
• 2009 ASTM D7471-09(2014) Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials
• 2009 ASTM D7471-09 Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials