ASTM B598-09
Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys

Standard No.

ASTM B598-09

Release Date

2009

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM B598-14

Latest

ASTM B598-14a

Scope

This practice may be used for approximating a limiting design stress at room temperature and, in some cases, for approximating the range of elastic behavior. Elastic limit, or the greatest stress that a material is capable of sustaining without any permanent strain remaining upon complete release of the stress, is a more technically accurate design parameter; however, the elastic limit is extremely difficult to measure in routine testing. Caution should be used in applying such values to predict the behavior of flat or wire springs in bending, torsion or other stress modes, or at temperatures other than that at which the determination is made.

1.1 This practice establishes the requirements for determining offset yield strength (0.01 %, 0.02 %, and 0.05 % offset) at room temperature. It is intended for copper alloys in tempers commonly used for spring applications, and materials thicker than 0.010 in. (0.25 mm).

1.1.1 The primary application of this practice is intended for flat strip materials that are used for springs; however, this practice can be used for other product forms, such as wire, rod, and bar.

1.2 Units8212;The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM B598-09 Referenced Document

• ASTM B950 Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys
• ASTM E4 Standard Practices for Force Verification of Testing Machines
• ASTM E6 Standard Terminology Relating to Methods of Mechanical Testing
• ASTM E74 Standard Practices for Calibration and Verification for Force-Measuring Instruments
• ASTM E83 Standard Practice for Verification and Classification of Extensometer

ASTM B598-09 history

• 2014 ASTM B598-14a Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys
• 2014 ASTM B598-14 Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys
• 2009 ASTM B598-09 Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys
• 1998 ASTM B598-98(2004) Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys
• 1998 ASTM B598-98 Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys