ISO 1652:2004
Rubber latex - Determination of apparent viscosity by the Brookfield test method

Standard No.

ISO 1652:2004

Release Date

2004

Published By

International Organization for Standardization (ISO)

Status

Be replaced 2011-03

Replace By

ISO 1652:2011

Latest

ISO 1652:2011

Scope

This part of ISO 1641 specifies the general dimensions of the following milling cutters with 7/24 taper shanks: — end mills, flat-ended or ball-nosed — standard series and long series (manual changers); — slot drills — short series and standard series (manual changers); — end mills, flat-ended — standard series and long series (automatic changers). Characteristics of 7/24 taper are in accordance with ISO 297 for manual changers and ISO 7388-1 for automatic changers. NOTE These same milling cutters with cylindrical shanks are dealt with in ISO 1641-1, and those with Morse taper shank having a tapped hole in ISO 1641-2.

ISO 1652:2004 history

• 2011 ISO 1652:2011 Rubber latex - Determination of apparent viscosity by the Brookfield test method
• 2004 ISO 1652:2004 Rubber latex - Determination of apparent viscosity by the Brookfield test method
• 1985 ISO 1652:1985 Rubber latex; Determination of viscosity
• 1974 ISO 1652:1974 Rubber latex — Determination of viscosity