This test method provides a measurement of alkalinity in acetone. The results of this measurement can be used for specification acceptance.
1.1 This test method covers the determination in acetone of alkalinity calculated as ammonia (NH3).
1.2 For specific hazard information and guidance, consult the supplier''s Material Safety Data Sheet.
1.3 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.
Copyright ©2024 All Rights Reserved