ASTM D2522-03(2008)
Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation

Standard No.

ASTM D2522-03(2008)

Release Date

2003

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D2522-03(2008)e1

Latest

ASTM D2522-03(2008)e2

Scope

Chlorine is normally present in polybutenes in small amounts, usually below 50 ppm, as organically bound chlorine. Inorganic chloride is normally not present.

Note 18212;The qualitative presence or absence of inorganic chloride may be tested by Test Method D 878.

1.1 This test method describes the determination of the total chloride content of polybutenes used for electrical insulation.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards information, see Section 8.

ASTM D2522-03(2008) Referenced Document

• ASTM D1193 Standard Specification for Reagent Water
• ASTM D878 Standard Test Method for Inorganic Chlorides and Sulfates in Insulating Oils

ASTM D2522-03(2008) history

• 2003 ASTM D2522-03(2008)e2 Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation
• 2003 ASTM D2522-03(2008)e1 Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation
• 2003 ASTM D2522-03(2008) Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation
• 2003 ASTM D2522-03 Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation
• 1995 ASTM D2522-95 Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation