ASTM A770/A770M-03(2007)
Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications

Standard No.

ASTM A770/A770M-03(2007)

Release Date

2003

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM A770/A770M-03(2012)

Latest

ASTM A770/A770M-03(2018)

Scope

1.1 This specification covers the procedures and acceptance standards for the determination of reduction of area using a tension test specimen whose axis is perpendicular to the rolled surfaces of steel plates 1 in. [25 mm] and greater in thickness. The principal purpose of the testing is to provide a measure of the resistance of a steel plate to lamellar tearing. (See Appendix X1.)

1.2 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.

ASTM A770/A770M-03(2007) history

• 2018 ASTM A770/A770M-03(2018) Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 2003 ASTM A770/A770M-03(2012)e1 Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 2012 ASTM A770/A770M-03(2012) Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 2003 ASTM A770/A770M-03(2007) Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 2003 ASTM A770/A770M-03 Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 1986 ASTM A770/A770M-86(2001) Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
• 2001 ASTM A770/A770M-86(1996) Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications