ASTM G38-01
Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens

Standard No.

ASTM G38-01

Release Date

2001

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM G38-01(2007)

Latest

ASTM G38-01(2021)

Scope

1.1 This practice describes the essential features of the design and machining, and procedures for stressing, exposing, and inspecting C-ring type of stress-corrosion test speci- mens. An analysis is given of the state and distribution of stress in the C-ring.

1.2 Specific considerations relating to the sampling process and to the selection of appropriate test environments are outside the scope of this practice.

1.3 The values stated in SI units are to be regarded as standard. The inch-pound units are provided for information.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM G38-01 history

• 2021 ASTM G38-01(2021) Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens
• 2001 ASTM G38-01(2013) Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens
• 2001 ASTM G38-01(2007) Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens
• 2001 ASTM G38-01 Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens
• 1973 ASTM G38-73(1995)E1 Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens