ASTM D5475-93(2002)
Standard Test Method for Nitrogen- and Phosphorus-Containing Pesticides in Water by Gas Chromatography with a Nitrogen-Phosphorus Detector

Standard No.

ASTM D5475-93(2002)

Release Date

1993

Published By

American Society for Testing and Materials (ASTM)

Status

Withdraw 2011-01

Latest

ASTM D5475-93(2002)

Scope

Nitrogen- and phosphorus-containing compounds are widely used in agriculture as pre-emergent agents to increase crop yields. Runoff from farmlands into lakes and streams as well as accidental discharge from irrigation systems into groundwater introduces these compounds into the environment. This discharge from agricultural areas along with possible health implications dictates a need to monitor the presence of these compounds.

1.1 This is a gas chromatographic (GC) test method applicable to the determination of certain nitrogen- and phosphorus-containing pesticides in ground water and finished drinking water. The analytes listed in have been validated using this test method.

1.2 This test method has been validated on reagent water and finished drinking water by 10 volunteer laboratories. Summary statistics were calculated for mean recovery, overall method precision and bias and single analyst precision using a computer program, Interlaboratory Method Validation Study (IMVS).

1.3 Collaborative study showed the test method to be acceptable for all analytes tested except merphos, which decomposed in the GC injection port.

1.4 This test method is restricted to use by or under the supervision of analysts experienced in the use of GC and in the interpretation of gas chromatograms. Each analyst must demonstrate the ability to generate acceptable results with this test method using the procedure described in 12.3.

1.5 Analytes that are not separated chromatographically, that is, analytes which have very similar retention times, cannot be individually identified and measured in the same calibration mixture or water sample unless an alternative technique for identification and quantitation exist (13.5).

1.6 When this test method is used to analyze unfamiliar samples for any or all of the analytes above, analyte identifications should be confirmed by at least one additional qualitative technique.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5475-93(2002) Referenced Document

• ASTM D1129 Standard Terminology Relating to Water*， 1999-04-19 Update
• ASTM D1192 Standard Guide for Equipment for Sampling Water and Steam in Closed Conduits*， 1998-01-01 Update
• ASTM D1193 Standard Specification for Reagent Water*， 1999-04-19 Update
• ASTM D2777 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water*， 1998-04-19 Update
• ASTM D3370 Standard Practices for Sampling Water from Closed Conduits*， 1995-09-10 Update
• ASTM D3694 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents*， 2017-12-15 Update

ASTM D5475-93(2002) history

• 1993 ASTM D5475-93(2002) Standard Test Method for Nitrogen- and Phosphorus-Containing Pesticides in Water by Gas Chromatography with a Nitrogen-Phosphorus Detector
• 1997 ASTM D5475-93(1997) Standard Test Method for Nitrogen- and Phosphorus-Containing Pesticides in Water by Gas Chromatography with a Nitrogen-Phosphorus Detector