ASTM D957-95(2006)e1
Standard Practice for Determining Surface Temperature of Molds for Plastics

Standard No.

ASTM D957-95(2006)e1

Release Date

1995

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D957-06

Latest

ASTM D957-21

Scope

1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.

1.2 The values stated in SI units are to be regarded as standard. The values in brackets are given for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

There is no similar ISO standard.

ASTM D957-95(2006)e1 history

• 2021 ASTM D957-21 Standard Practice for Determining Surface Temperature of Molds for Plastics
• 2012 ASTM D957-12 Standard Practice for Determining Surface Temperature of Molds for Plastics
• 2006 ASTM D957-06 Standard Practice for Determining Surface Temperature of Molds for Plastics
• 1995 ASTM D957-95(2006)e1 Standard Practice for Determining Surface Temperature of Molds for Plastics
• 1995 ASTM D957-95(2000)e1 Standard Practice for Determining Surface Temperature of Molds for Plastics
• 2000 ASTM D957-95 Standard Practice for Determining Surface Temperature of Molds for Plastics