ASTM D2193-06
Standard Test Method for Hydroquinone in Vinyl Acetate

Standard No.
ASTM D2193-06
Release Date
2006
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D2193-06(2012)
Latest
ASTM D2193-22
Scope

This test method provides a measurement of inhibitor level in vinyl acetate. The results of these measurements can be used for specification acceptance.

1.1 This test method covers the determination of hydroquinone in the range from 1 to 20 ppm in refined, commercially available, vinyl acetate.

1.2 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with Practice E 29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

ASTM D2193-06 Referenced Document

  • ASTM D1193 Standard Specification for Reagent Water
  • ASTM E29 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

ASTM D2193-06 history

Standard Test Method for Hydroquinone in Vinyl Acetate


Copyright ©2024 All Rights Reserved