1.1 These test methods cover solventless varnishes used primarily as electrical, mechanical, and environmental protection for electrical equipment.
1.2 These test methods are used on solventless varnishes that are applied by dipping (at atmospheric pressure conditions or under vacuum or pressure), spraying, or brushing for the purpose of impregnating or sealing electrical equipment. The following test methods are included:
Property Tests (Uncured): Section Density 7 Flash Point 8 Gel Time 9 Monomer Content 10 Rheological Properties (Non-Newtonian) 11 Brookfield Viscosity 12 Performance Property Tests (cured):Bond Strength 13 Coating Thickness 14 Dielectric Strength 15 and 16 Permittivity and Dissipation Factor 171.3 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 8.3, 15.5.1, and 15.5.2.
Copyright ©2024 All Rights Reserved