ASTM D4972-01(2007)
Standard Test Method for pH of Soils
- Standard No.
- ASTM D4972-01(2007)
- Release Date
- 2001
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D4972-13
- Latest
- ASTM D4972-19
- Scope
The pH of the soil is a useful variable in determining the solubility of soil minerals and the mobility of ions in the soil and assessing the viability of the soil-plant environment.
pH measurements are made in both water and a calcium chloride solution because the calcium displaces some of the exchangeable aluminum. The low ionic strength counters the dilution effect on the exchange equilibrium by setting the salt concentration of the solution closer to that expected in the soil solution. The pH values obtained in the solution of calcium chloride are slightly lower than those measured in water due to the release of more aluminum ions which then hydrolyses. Therefore, both measurements are required to fully define the character of the soilrsquo;pH.
For the purpose of this test method the test soil must be sieved through a No. 10 sieve (2 mm sieve mesh openings). Measurements on soils or soil fractions having particle sizes larger than 2 mm by this test method may be invalid. If soil or soil fractions with particles larger than 2 mm are used, it must be stated in the report since the results may be significantly different.
All water used for this test method must be ASTM Type III or better. Type III water is defined by Specification D 1193
. It is prepared by distillation, ion exchange, reverse osmosis, or a combination thereof. 1.1 This test method covers the measurement of the pH of soils for uses other than for corrosion testing. Such measurements are used in the agricultural, environmental, and natural resources fields. This measurement determines the degree of acidity or alkalinity in soil materials suspended in water and a 0.01 M calcium chloride solution. Measurements in both liquids are necessary to fully define the soil's pH. This variable is useful in determining the solubility of soil minerals and the mobility of ions in the soil and assessing the viability of the soil-plant environment. A more detailed discussion of the usefulness of this parameter is not warranted here; however, it can be found in many discussions of the subject. A few such discussions are given as Refs
(1-6) at the end of the text.1.2 The values given in SI units are to be regarded as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D4972-01(2007) Referenced Document
- ASTM C670 Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
- ASTM D1193 Standard Specification for Reagent Water
- ASTM D3740 Standard Practice for Minimum Requirements for Agencies Engaged in the Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
- ASTM D653 Standard Terminology Relating to Soil, Rock, and Contained Fluids
- ASTM G51 Standard Test Method for Measuring pH of Soil for Use in Corrosion Testing
ASTM D4972-01(2007) history
- 2019 ASTM D4972-19 Standard Test Methods for pH of Soils
- 2018 ASTM D4972-18 Standard Test Methods for pH of Soils
- 2013 ASTM D4972-13 Standard Test Method for pH of Soils
- 2001 ASTM D4972-01(2007) Standard Test Method for pH of Soils
- 2001 ASTM D4972-01 Standard Test Method for pH of Soils
- 1995 ASTM D4972-95a Standard Test Method for pH of Soils
