ASTM F1659-95
Standard Test Method for Bending and Shear Fatigue Testing of Calcium Phosphate Coatings on Solid Metallic Substrates
- Standard No.
- ASTM F1659-95
- Release Date
- 1995
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- 2005-12
- Latest
- ASTM F1659-95
- Scope
1.1 This test method covers the procedure for the performance of calcium phosphate ceramic coatings in shear and bending fatigue modes. In the shear fatigue mode this test method evaluates the adhesive and cohesive properties of the coating on a metallic substrate. In the bending fatigue mode, this test method evaluates both the adhesion of the coating as well as the effects that the coating may have on the substrate material. These test methods are limited to testing in air at ambient temperature. These test methods are not intended for application in fatigue tests of components or devices; however, the test method that most closely replicates the actual loading configuration is preferred.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F1659-95 Referenced Document
- ASTM E466 Standard Practice for Conducting Force Controlled Constant Amplitude Axial Fatigue Tests of Metallic Materials*， 1996-04-19 Update
- ASTM E467 Standard Practice for Verification of Constant Amplitude Dynamic Forces in an Axial Fatigue Testing System*， 1998-04-19 Update
- ASTM E468 Standard Practice for Presentation of Constant Amplitude Fatigue Test Results for Metallic Materials
- ASTM E6 Standard Terminology Relating to Methods of Mechanical Testing*， 1999-04-19 Update
ASTM F1659-95 history
- 1995 ASTM F1659-95 Standard Test Method for Bending and Shear Fatigue Testing of Calcium Phosphate Coatings on Solid Metallic Substrates
