ASTM D6181-03
Standard Test Method for Measurement of Turbidity in Mineral Insulating Oil of Petroleum Origin

Standard No.

ASTM D6181-03

Release Date

2003

Published By

American Society for Testing and Materials (ASTM)

Status

Withdraw 2012-01

Latest

ASTM D6181-03

Scope

This test method uses a ratio turbidimetric optical system to measure the turbidity of insulating oils relative to turbidity standards. Cloudiness or turbidity is attributed to matter whose diameter is approximately 20 % of the wavelength of the incident light. Increasing turbidity signifies increasing transformer fluid contamination, either from external sources or internal chemical reactions (such as oxidation) that produce fine particulate matter. Other turbidity sources, such as water droplets or gas bubbles, are not of interest in this evaluation of insulating oils. The elimination of these interferences is described in 6.2 and 6.6. This test method quantifies changes which may not be apparent to the unaided human eye.

1.1 This test method covers the laboratory procedure that ascertains the quantity of suspensions in insulating oils of petroleum origin using a nephelometric measurement technique to determine the fluid''s turbidity. This test method is designed to reveal changes that may occur to these oils.

1.2 This test method is applicable for turbidities in the range of 0.1 to 500 Nephelometric Turbidity Units (NTU).

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D6181-03 Referenced Document

• ASTM D1533 Standard Test Method for Water in Insulating Liquids by Coulometric Karl Fischer Titration*， 2024-04-19 Update
• ASTM D1698 Standard Test Method for Sediments and Soluble Sludge in Service-Aged Insulating Oils
• ASTM D1889 Standard Test Method for Turbidity of Water
• ASTM D4652 Standard Specification for Silicone Fluid Used for Electrical Insulation
• ASTM D5180 Standard Test Method for Quantitative Test for Turbidity in Clear Liquids
• ASTM D923 Standard Practices for Sampling Electrical Insulating Liquids
• ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods

ASTM D6181-03 history

• 2003 ASTM D6181-03 Standard Test Method for Measurement of Turbidity in Mineral Insulating Oil of Petroleum Origin
• 1997 ASTM D6181-97 Standard Test Method for Measurement of Turbidity in Mineral Insulating Oil of Petroleum Origin