ASTM D1558-99(2004)e1
Standard Test Method for Moisture Content Penetration Resistance Relationships of Fine-Grained Soils

Standard No.

ASTM D1558-99(2004)e1

Release Date

1999

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D1558-10

Latest

ASTM D1558-10

Scope

This test method is used with Methods A and B of Test Methods D 698 to develop relationships between moisture content, density, and penetration resistance. These relationships are used with a previously prepared family of moisture-penetration curves as a rapid field test to determine the approximate amount of moisture in the soil.

Note 18212;When a penetration-resistance measurement of material in place is compared at a given moisture content with penetration-density curves prepared at a specified compactive effort, an approximate check of compaction (density) may be obtained.

Penetration resistance determinations are not reliable for very dry molded soil specimens or very granular soils.

Note 28212;Notwithstanding the statements on precision and bias contained in this standard, the precision of this test method is dependent on the competence of the personnel performing it and the suitability of the equipment and the facilities used. Agencies that meet the criteria of Practice D 3740 are generally considered capable of competent and objective testing. Users of this test method are cautioned that compliance with Practice D 3740 does not in itself assure reliable testing. Reliable testing depends on many factors; Practice D 3740 provides a means of evaluating some of those factors.

1.1 This test method is for establishing the moisture-penetration resistance relationships of fine-grained soils as determined by the soil penetrometer.

1.2 The values stated in inch-pound units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D1558-99(2004)e1 Referenced Document

• ASTM C670 Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
• ASTM D2216 Standard Test Method for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass
• ASTM D3740 Standard Practice for Minimum Requirements for Agencies Engaged in the Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
• ASTM D4753 Standard Specification for Evaluating, Selecting, and Specifying Balances and Scales for Use in Soil, Rock, and Construction Materials Testing
• ASTM D653 Standard Terminology Relating to Soil, Rock, and Contained Fluids
• ASTM D698 Standard Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort (12 400 ft-lbf/ft³ (600 kN-m/m³))*， 2024-04-19 Update
• ASTM E380 Standard Practice for Use of the Internation System of Units (SI) (the Modernized Metric System)
• ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

ASTM D1558-99(2004)e1 history

• 2010 ASTM D1558-10 Standard Test Method for Moisture Content Penetration Resistance Relationships of Fine-Grained Soils
• 1999 ASTM D1558-99(2004)e1 Standard Test Method for Moisture Content Penetration Resistance Relationships of Fine-Grained Soils
• 1999 ASTM D1558-99 Standard Test Method for Moisture Content Penetration Resistance Relationships of Fine-Grained Soils