This test method is intended for use as a control, acceptance, and assessment test.
Moisture can seriously affect the processability of plastics. It is possible that high moisture content will cause surface imperfections (that is, splay or bubbling) or degradation by hydrolysis. Low moisture (with high temperature) has been known to cause solid phase polymerization.
The physical properties of some plastics are greatly affected by the moisture content.
1.1 This test method covers the quantitative determination of water down to 20 ppm in plastics using a relative humidity sensor.
1.2 Values stated in SI units are to be regarded as standard.
1.3 Specimens tested in this test method can reach or exceed 250176;C, use caution when handling them after testing has completed.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no similar or equivalent ISO standard.
Copyright ©2024 All Rights Reserved