This International Standard is applicable to portable and transportable contamination meters
and monitors designed for the direct measurement or the direct detection of surface
contamination by photon radiation emitting radionuclides and which comprise at least:
- a detection assembly (comprising counter tube, scintillation detector or semiconductor
detector, etc.), which may be connected either rigidly or by means of a flexible cable or
incorporated into a single assembly;
- a measurement assembly.
The standard is applicable to:
- photon surface contamination meters;
- photon surface contamination monitors.
The standard is applicable to detection assemblies that are designed to measure photon
contamination from radionuclides which emit photons with energy in excess of 5 keV. In
particular, this standard should be used to assess the performance of assemblies used to
demonstrate that material is free from surface contamination by photon emitting radionuclides.
This standard is also applicable to special purpose assemblies and to assemblies specifically
designed to provide limited spectroscopic information to the user.
NOTE These detection assemblies may be used to measure photon emissions from radionuclides that also emit
alpha and beta radiations, where the alpha and beta emissions may be shielded due to the nature of the
contamination. If shielding of the radioactive emissions occurs, then strictly speaking, the contamination is near to
rather than on the surface of the article being monitored.
The object of this standard is to lay down standard requirements and to give examples of
acceptable methods, and also to specify general characteristics, general test conditions,
radiation characteristics, electrical safety, environmental characteristics, and the requirements
of the identification certificate for photon contamination meters and monitors.
IEC 62363:2008 Referenced Document
IEC 60050-393:2003 International Electrotechnical Vocabulary - Part 393: Nuclear instrumentation: Physical phenomena and basic concepts
IEC 60050-394:2007 International Electrotechnical Vocabulary - Part 394: Nuclear instrumentation - Instruments, systems, equipment and detectors
IEC 60086 Primary batteries - ALL PARTS*, 2016-07-13 Update
IEC 60325:2002 Radiation protection instrumentation - Alpha, beta and alpha/beta (beta energy 60 keV) contamination meters and monitors
IEC 61187:1993 Electrical and electronic measuring equipment; documentation
ISO 11929-1:2000 Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 1: Fundamentals and application to counting measurements without the influence of sample treatment
ISO 7503-1:1988 Evaluation of surface contamination; part 1: beta-emitters (maximum beta energy greater than 0,15 MeV) and alpha-emitters
ISO 7503-3:1996 Evaluation of surface contamination - Part 3: Isomeric transition and electron capture emitters, low energy beta-emitters (<(Index)max> 0,15 MeV)
ISO 8769-2:1996 Reference sources for the calibration of surface contamination monitors - Part 2: Electrons of energy less than 0,15 MeV and photons of energy less than 1,5 MeV