DIN EN ISO 7233:2008 PDF

Standard No.: DIN EN ISO 7233:2008
Release Date: 2008
Published By: German Institute for Standardization
Status: Be replaced
Replace By: DIN EN ISO 7233:2017; DIN EN ISO 7233 E:2015-10
Latest: DIN EN ISO 7233:2017; DIN EN ISO 7233:2020; DIN EN ISO 7233:2021-08; DIN EN ISO 7233 E:2015-10
Replace: DIN EN ISO 7233:1995

Scope: This International Standard specifies three methods for determining the resistance to vacuum of hoses and hose assemblies manufactured from plastic or rubber. Applicable dimensions of hoses for each method are as follows: -- method A m for hoses of nominal bore up to and including 80 mm; -- method B -- for hoses of nominal bore greater than 80 mm; -- method C -- for hoses of all dimensions. Methods A and B can also be used to check the adhesion of the lining to the reinforcement (delamination) in a length of hard-wall hose or hose assembly.

DIN EN ISO 7233:2008 Referenced Document

ISO 23529 Rubber - General procedures for preparing and conditioning test pieces for physical test methods*， 2016-11-01 Update
ISO 4671:1999 Rubber and plastics hoses and hose assemblies - Methods of measurement of dimensions

2021 DIN EN ISO 7233:2021 Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2021); German version EN ISO 7233:2021
1970 DIN EN ISO 7233 E:2020-02 Determination of vacuum resistance of rubber and plastic hoses and hose assemblies (draft)
2020 DIN EN ISO 7233 E:2020 Draft Document - Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO/DIS 7233:2020); German and English version prEN ISO 7233:2020
2017 DIN EN ISO 7233:2017 Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2016); German version EN ISO 7233:2016
2008 DIN EN ISO 7233:2008 Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2006); German version EN ISO 7233:2008
0000 DIN EN ISO 7233:1995