JB/T 10185-2008 (English Version) PDF

Scope: This standard specifies the terms and definitions, symbols, codes, product models, specifications, signs, normal working and installation conditions, technical requirements, test methods and inspection rules of HK series isolation switches. This standard is applicable to circuits with AC frequencies of 5OHz and 60Hz, rated voltages of single-phase 230V (220V), three-phase 400V (380V) and below, and rated currents up to 100A for use as main switches, branch switches, lamps, electric heaters, etc. The operating isolation switch of electrical equipment is used to manually connect and disconnect load circuits and isolate power sources infrequently. In addition, it can also be used to directly switch on and off a single low-power AC asynchronous motor infrequently.

JB/T 10185-2008 Referenced Document

GB 13539.1-2002 Low-voltage fuses--Part 1: General requirements
GB 14048.1-2006 Low-voltage switchgear and controlgear. Part 1: General rules
GB 14048.3-2002 Low-voltage switchgear and controlgear Part 3: Switches,disconnectors,switch-disconnectors and fuse-combination units
GB/T 2423.4-1993 Basic environmental testing procedures for electric and electronic products. Test Db:Damp heat,cyclic
GB/T 2900.18-1992 Electrotechnical terminology--Low voltage apparatus
GB/T 4207-2003 Method for determining the comparative and the proof tracking indices of solid insulating materials under moist conditions
GB/T 5169.10-2006 Fire hazard testing for electric and electronic products Part 10: Glow/hot-wire based test methods Glow-wire apparatus and common test procedure