- Standard No.
- IEC 60512-16-18:2008
- Release Date
- 2008
- Published By
- International Electrotechnical Commission (IEC)
- Latest
-
IEC 60512-16-18:2008
- Replace
-
IEC 48B/1875/FDIS:2008
IEC 60512-8:1993
- Scope
- This part of IEC 60512, when required by the detail specification, is used for testing
electomechanical components within the scope of technical committee 48. It may also be
used for similar devices when specified in a detail specification.
The object of this part of IEC 60512 is to detail a standard test method to measure the
deflection of a simulated contact in its cavity or housing.
Although this test method is intended for cylindrical male contacts, and is particularly
applicable to those where the contacts fit into an insert, which may have some elasticity, its
use for contacts with other geometries and housing details, is not excluded. In which case,
the detail specification should contain sufficient detail, given under Clause 5, to enable the
test to be done.
IEC 60512-16-18:2008 Referenced Document
- IEC 60512-1-1 Connectors for electronic equipment - Tests and measurements - Part 1-1: General examination; Test 1a: Visual examination
IEC 60512-16-18:2008 history
- 2008 IEC 60512-16-18:2008 Connectors for electronic equipment - Tests and measurements - Part 16-18: Mechanical tests on contacts and terminations - Test 16r: Deflection of contacts, simulation
IEC 60512-16-18:2008 Connectors for electronic equipment - Tests and measurements - Part 16-18: Mechanical tests on contacts and terminations - Test 16r: Deflection of contacts, simulation has been changed from IEC 60512-8:1993 Electromechanical components for electronic equipment; basic testing procedures and measuring methods; part 8: connector tests (mechanical) and mechanical tests on contacts and terminations.