This standard gives procedures for equipment reliability compliance and determination testing. Part 1 contains general requirements to be considered in the planning of the tests. Parts 2 to 11 inclusive contain specific procedures which are intended for use during the phases of planning, testing, data collecting and data analysing. Selection of the most appropriate procedures is made by the user of the standard.
Other parts of this standard:
Part 2: Guidance for the Design of Test Cycles for Equipment Reliability Testing.
Part 3: Preferred Test Conditions for Equipment Reliability Testing.
Part 4: Procedures for Determining Point Estimates and Confidence Limits from Equipment Reliability
Determination Tests. Part 5: Compliance Test Plans for Success Ratio. Part 6: Tests for the Validity of a Constant Failure R?te Assumption. Part 7: Compliance Test Plans for Failure R?te and Mean Time Between Failures Assuming Constant
Failure R?te. Part 8: Tests for the Validity of a Non-constant Failure R?te Assumption.
Part 9: Compliance Test Plans Assuming Weibull Distribution of Times to Failure.
Part 10: Compliance Test Plans Assuming Normal Distribution of Times to Failure.
Part 11: Flow Chart Describing Preparations for and Execution of Reliability Tests.