This International Standard specifies a method of testing the continuous wave (cw) laser resistance of the shaft of a tracheal tube. Other components of the system, such as the inflation system and cuff, are outside the scope of this International Standard.
The specified test method shall be used to measure and describe the properties of materials, products or assemblies in response to heat and flame under controlled laboratory conditions and shall not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all the factors which are pertinent to an assessment of the hazard of a particular end use. Caution should be observed in interpreting these results, since the direct applicability of the result of this test method to the clinical situation has not been fully established.
NOTE This test method may involve hazardous materials, operations, and equipment. This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ISO 11990:2003 history
2018ISO 11990:2018 Lasers and laser-related equipment - Determination of laser resistance of tracheal tube shaft and tracheal tube cuffs
2003ISO 11990:2003 Optics and optical instruments - Lasers and laser-related equipment - Determination of laser resistance of tracheal tube shafts
1999ISO 11990:1999 Optics and optical instruments - Lasers and laser-related equipment - Determination of laser resistance of tracheal tube shafts