BS EN 1917:2002 PDF

Scope: This European Standard specifies performance requirements as defined in Table 1 and describes test methods for precast concrete units for inspection chambers designed to be used for inverts not exceeding 2 metres deep and manholes, of circular, rectangular (with or without chamfered or rounded corners) or elliptical internal shape, unreinforced, steel fibre and reinforced, with nominal sizes and normal length not exceeding DN 1 250 (circular) or LN 1 250 (rectangular or elliptical). The intended use is to permit access to, and to allow aeration of, drain or sewer systems for the conveyance of sewage, rainwater and surface water under gravity or occasionally at low head of pressure, mainly installed in areas subjected to vehicular and/or pedestrian traffic. Requirements for joints (elastomeric, plastomeric or other sealing materials, either integrated in the unit or supplied separately) are also specified. Provision is made for the evaluation of conformity of units to this European Standard. Marking conditions are included.

BS EN 1917:2002 Referenced Document

EN 10002-1 Metallic Materials - Tensile Testing - Part 1: Method of Test at Ambient Temperature
EN 1916 Concrete pipes and fittings, unreinforced, steel fibre and reinforced*， 2024-04-17 Update
EN 681-1 Elastomeric seals Material requirements for pipe joint seals used in water and drainage applications Part 1: Vulcanized rubber (Incorporates Amendments A1: 1998 and A2: 2002; Incorporating Corrigendum August 2002; Incorporates Amendment A3: 2005)
ISO 10544 Cold-reduced steel wire for the reinforcement of concrete and the manufacture of welded fabric*， 2024-01-15 Update
ISO 4012 Concrete; Determination of compressive strength of test specimens

0000 BS EN 1917:2002(2008)
2002 BS EN 1917:2002 Concrete manholes and inspection chambers, unreinforced, steel fibre and reinforced
0000 BS 5911-200:1994
0000 BS 5911-2:1982