ISO 5414-2:2002 PDF

Scope: This part specifies the dimensions and markings of the connecting part of a tool chuck (end mill chuck) with fastening screws. This chuck is used for the transmission of flattened straight shank milling cutters according to GB/T 6131.2. . This part specifies two connection types: 　——Manual tool change according to ISO 297 and automatic tool change according to GB/T 10944.1 Taper shank chuck with 7:24, suitable for manual and automatic single or double flattened types Replace the knife handle. Note: The dimensions of the No. 30 7:24 taper shank tool holder for automatic tool change given in this section are not standardized. --- GB/T 1443 and GB/T 4133 Morse taper shank chucks are only suitable for single-flattened tool holders. Note: The dimensions of the tool holder transmission system are in accordance with GB/T 6133.1.

ISO 5414-2:2002 Referenced Document

GB/T 10944.1 Tool shanks with 7/24 taper for automatic tool changers.Part 1:Dimensions and designation of shanks of forms A,AD,AF,U,UD and UF*， 2013-12-31 Update
GB/T 1443 Self-clamping cones for machine tools and tool holders*， 2016-09-01 Update
GB/T 4133 The type and dimensions for positive drive of morse tapers
GB/T 6131.2 Cylindrical shanks for milling cutters.Part 2: Types and sizes of flatted cylindrical shanks*， 2006-07-20 Update
GB/T 6133.1 Tool chucks for flated parallel shank tools .Part 1: Dimensions of the driving system of tool shanks*， 2006-07-20 Update
ISO 297 7/24 tapers for tool shanks for manual changing

2002 ISO 5414-2:2002 Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Part 2: Connecting dimensions of chucks and designation
1982 ISO 5414-2:1982 Tool chucks (end mill holders) with clamp screws for flatted parallel shank tools; Part 2 : Connecting dimensions of chucks