DIN EN ISO 1167-4:2008 PDF

Scope: This part of ISO 1167 specifies the procedure for the preparation of both end-load-bearing and non-end-load-bearing assemblies, for the determination of their resistance to internal hydrostatic pressure according to ISO 1167-1. NOTE The assemblies consist of a selection of pipes, fittings, valves, fusion joints or adhesively bonded joints.

DIN EN ISO 1167-4:2008 Referenced Document

EN 1066 Adhesives - Sampling
EN 1067 Adhesives - Examination and preparation of samples for testing*， 2024-04-18 Update
ISO 11413 Plastics pipes and fittings — Preparation of test piece assemblies between a polyethylene (PE) pipe and an electrofusion fitting*， 2019-03-12 Update
ISO 11414 Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion*， 2009-02-01 Update
ISO 1167-1 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids - Determination of the resistance to internal pressure - Part 1: General method
ISO 3126 Plastics piping systems - Plastics components - Determination of dimensions

2008 DIN EN ISO 1167-4:2008-02 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids - Determination of the resistance to internal pressure - Part 4: Preparation of assemblies (ISO 1167-4:2007); German version EN ISO 1167-4:2007
2008 DIN EN ISO 1167-4:2008 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids - Determination of the resistance to internal pressure - Part 4: Preparation of assemblies (ISO 1167-4:2007); English version of DIN EN ISO 1167-4:2008-02
0000 DIN EN ISO 1167-4:2006
0000 DIN EN 921:1995