DIN EN 74-3:2007 PDF

Scope: EN 74-3 specifies for plain and profiled base plates and loose spigots to be used with 48,3 mm diameter tubes in scaffolds and falsework: -- materials; -- design requirements; -- test procedure; -- assessment. A base plate with a means of limited vertical adjustment, called a "base jack", is dealt with in EN 12811-1. NOTE In the text of this standard, the term "loose spigot" is used instead of the "spigot pin" in the title.

DIN EN 74-3:2007 Referenced Document

EN 12811-1:2003 Temporary works equipment - Part 1: Scaffolds; Performance requirements and general design*， 2024-04-18 Update
EN 12811-2:2004 Temporary works equipment - Part 2: Information on materials
EN 12811-3 Temporary works equipment - Part 3: Load testing
EN 74-1:2005 Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 1: Couplers for tubes - Requirements and test procedures*， 2024-04-18 Update

2007 DIN EN 74-3 Berichtigung 1:2007-10 Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 3: Plain base plates and spigot pins - Requirements and test procedures; German version EN 74-3:2007, Corrigenda to DIN EN 74-3:2007-07
2007 DIN EN 74-3:2007-07 Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 3: Plain base plates and spigot pins - Requirements and test procedures; German version EN 74-3:2007
2007 DIN EN 74-3:2007 Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 3: Plain base plates and spigot pins - Requirements and test procedures; English version of DIN EN 74-3:2007-07
0000 DIN EN 74-3:2005
1970 DIN EN 74:1988