ISO 16792:2006
Technical product documentation - Digital product definition data practices
- Standard No.
- ISO 16792:2006
- Release Date
- 2006
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 16792:2015
- Latest
- ISO 16792:2021
- Scope
- This International Standard specifies requirements for the preparation, revision and presentation of digital product definition data, hereafter referred to as data sets. It supports two methods of application: model-only, and model and drawing in digital format. Its structure presents requirements common to both methods followed by clauses providing for any essential, differing requirements for each method. Additionally, its use in conjunction with computer aided design (CAD) systems could assist in the progression towards improved modelling and annotation practices for CAD and engineering disciplines, as well as serving as a guideline for IT engineers. The aspects specified in this International Standard refer mainly, but not exclusively, to requirements that differ or are additional to those provided in existing, related standards. Where no such requirements are identified, it is safe to assume that the appropriate existing ISO standards are instead applicable.
ISO 16792:2006 Referenced Document
- ISO 1101:2004 Geometrical Product Specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
- ISO 11442:2006 Technical product documentation - Document management
- ISO 129-1:2004 Technical drawings - Indication of dimensions and tolerances - Part 1: General principles
- ISO 1302 Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation — Amendment 2: Indication of material ratio requirements
- ISO 14660-1:1999 Geometrical Product Specifications (GPS) - Geometrical features - Part 1: General terms and definitions
- ISO 16016:2000 Technical product documentation - Protection notices for restricting the use of documents and products
- ISO 2692 Geometrical product specifications (GPS) - Geometrical tolerancing - Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR)*， 2021-06-01 Update
- ISO 2768-1:1989 General tolerances; part 1: tolerances for linear and angular dimensions without individual tolerance indications
- ISO 3098-0:1997 Technical product documentation - Lettering - Part 0: General requirements
- ISO 3098-5:1997 Technical product documentation - Lettering - Part 5: CAD lettering of the Latin alphabet, numerals and marks
- ISO 31-0:1992 Quantities and units; part 0: general principles
- ISO 406 Technical drawings; Tolerancing of linear and angular dimensions
- ISO 5457:1999 Technical product documentation - Sizes and layout of drawing sheets
- ISO 5458 Geometrical product specifications (GPS) - Geometrical tolerancing - Pattern and combined geometrical specification*， 2018-05-01 Update
- ISO 5459:1981 Technical drawings; Geometrical tolerancing; Datums and datum-systems for geometrical tolerances
- ISO 7083 Technical product documentation — Symbols used in technical product documentation — Proportions and dimensions*， 2021-05-14 Update
- ISO 7200:2004 Technical product documentation - Data fields in title blocks and document headers
- ISO 8015:1985 Technical drawings; Fundamental tolerancing principle
ISO 16792:2006 history
- 2021 ISO 16792:2021 Technical product documentation - Digital product definition data practices
- 2015 ISO 16792:2015 Technical product documentation - Digital product definition data practices
- 2006 ISO 16792:2006 Technical product documentation - Digital product definition data practices
