DIN EN ISO 8033:2006 PDF

Scope: Adequate adhesion between the various components of a hose is essential if it is to perform satisfactorily in service. This International Standard specifies methods for the determination of the adhesion between lining and reinforcement, between cover and reinforcement, between reinforcement layers, between cover and outer lamination (thin layer of material outside the cover for protection) and between lining and inner lamination (thin layer of material inside the lining to reduce permeation of fluid into the lining). It covers all bore sizes and the following types of hose construction: — woven textile fabric; — braided textile fabric; — knitted textile fabric; — circular-woven textile fabric; — textile spiral; — textile cord; — wire braid; — wire spiral; — hoses containing a supporting helix.

DIN EN ISO 8033:2006 Referenced Document

ISO 23529 Rubber - General procedures for preparing and conditioning test pieces for physical test methods*， 2016-11-01 Update
ISO 5893:2002 Rubber and plastics test equipment - Tensile, flexural and compression types (constant rate of traverse) - Specification
ISO 6133 Rubber and plastics - Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength*， 2015-08-01 Update

2017 DIN EN ISO 8033:2017-04 Rubber and plastics hoses - Determination of adhesion between components (ISO 8033:2016); German version EN ISO 8033:2017
2017 DIN EN ISO 8033:2017 Rubber and plastics hoses - Determination of adhesion between components (ISO 8033:2016); German version EN ISO 8033:2017
2006 DIN EN ISO 8033:2006 Rubber and plastics hoses - Determination of adhesion between components (ISO 8033:2006); English version of DIN EN ISO 8033:2006-11
0000 DIN EN ISO 8033:2004
0000 DIN EN 28033:1993