ISO 8033:2006 PDF

Scope: Adequate adhesion between the various components of a hose is essential if it is to perform satisfactorily in service. This International Standard specifies methods for the determination of the adhesion between lining and reinforcement, between cover and reinforcement, between reinforcement layers, between cover and outer lamination (thin layer of material outside the cover for protection) and between lining and inner lamination (thin layer of material inside the lining to reduce permeation of fluid into the lining). It covers all bore sizes and the following types of hose construction: — woven textile fabric; — braided textile fabric; — knitted textile fabric; — circular-woven textile fabric; — textile spiral; — textile cord; — wire braid; — wire spiral; — hoses containing a supporting helix.

ISO 8033:2006 Referenced Document

ISO 23529 Rubber - General procedures for preparing and conditioning test pieces for physical test methods*， 2016-11-01 Update
ISO 5893:2002 Rubber and plastics test equipment - Tensile, flexural and compression types (constant rate of traverse) - Specification
ISO 6133 Rubber and plastics - Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength*， 2015-08-01 Update

2016 ISO 8033:2016 Rubber and plastics hoses - Determination of adhesion between components
2006 ISO 8033:2006 Rubber and plastics hoses - Determination of adhesion between components
1991 ISO 8033:1991 Rubber and plastics hose; determination of adhesion between components
1985 ISO 8033:1985 Rubber and plastics hose — Determination of adhesion between components