DIN 5480-15:2006
Involute splines based on reference diameters - Part 15: Inspection
- Standard No.
- DIN 5480-15:2006
- Release Date
- 2006
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN 5480-15:2006-03
- Latest
- DIN 5480-15 Berichtigung 1:2009-01
- Replace
- DIN 5480-15:2004 DIN 5480-15:1974
- Scope
- This standard applies to involute splines and spline joints in accordance with DIN 5480-1 and DIN 5480-2. It defines the acceptance testing of such splines and describes the gauges to be used and their verification.
DIN 5480-15:2006 Referenced Document
- DIN 3960 Definitions, parameters and equations for involute cylindrical gears and gear pairs
- DIN 3961 Tolerances for Cylindrical Gear Teeth; Bases
- DIN 3967 System of Gear Fits; Backlash, Tooth Thickness Allowances, Tooth Thickness Tolerances; Principles
- DIN 5480-1 Involute splines based on reference diameters - Part 1: Generalities
- DIN 5480-2 Involute splines based on reference diameters - Part 2: Nominal and inspection dimensions*， 2015-03-01 Update
- DIN ISO 1101
- ISO 4156 Straight cylindrical involute splines; metric module, side fit; generalities, dimensions and inspection; amendment 1; section 3: inspection
- ISO 5459:1981 Technical drawings; Geometrical tolerancing; Datums and datum-systems for geometrical tolerances
DIN 5480-15:2006 history
- 2009 DIN 5480-15 Berichtigung 1:2009-01 Involute splines based on reference diameters - Part 15: Inspection, Corrigendum to DIN 5480-15:2006-03
- 2006 DIN 5480-15:2006-03 Involute splines based on reference diameters - Part 15: Inspection
- 2006 DIN 5480-15:2006 Involute splines based on reference diameters - Part 15: Inspection
- 1970 DIN 5480-15:1974 Involute splines based on reference diameters - Part 15: Inspection
