ANSI/ASTM B574:1999
Specification for Low-Carbon Nickel-Molybdenum-Chromium, Low-Carbon Nickel-Chromium-Molybdenum and Low-Carbon Nickel-Chromium-Molybdenum-Tungsten Alloy Rod

Standard No.

ANSI/ASTM B574:1999

Release Date

1999

Published By

American National Standards Institute （ANSI)

Latest

ANSI/ASTM B574:1999

Scope

This specification covers rod of low-carbon nickel-molybdenum-chromium alloys (UNS N10276, N06022, and N06455) , low-carbon nickel-chromium-molybdenum alloy (UNS N06059), and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service. The following products are covered under this specification:Rods 5/16 to 3/4 in. (7.94 to 19.05 mm), exclusive, in diameter, hot or cold finished, solution annealed and pickled, or mechanically descaled. Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm), inclusive, in diameter, hot or cold finished, solution annealed, ground or turned.The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

ANSI/ASTM B574:1999 history

• 1999 ANSI/ASTM B574:1999 Specification for Low-Carbon Nickel-Molybdenum-Chromium, Low-Carbon Nickel-Chromium-Molybdenum and Low-Carbon Nickel-Chromium-Molybdenum-Tungsten Alloy Rod