1.1 These requirements cover the test methods for measuring the fire performance of sheet plastics used
in semi-conductor wet bench tool construction
1.2 Plastic materials that are classified as Class 1 or Class 2 demonstrate limited fire propagation without
the use of sprinklers
1.3 Variations from the construction or conditions that are tested are capable of substantially changing the
performance characteristics of the plastic
1.4 This standard is not intended for evaluation of small plastic components used in semi-conductor tool
constructions such as tubing or wiring
1.5 This standard does not measure mechanical or structural properties of plastic．and this standard does
not measure the hazards from the smoke generated by the plastic material
1.6A product that contalns featu res，characteristlcs，cornponents．materlals，or systems new or different
f∞m those covered by the requirements in this standard and that involves a risk of fire or of electric shock
0r㈨urv to persons shall be evaluated using appropriate additional comportent and end-product
requirements to maintain the level of safetv as originaIly anticlpated by the Intent of this standard A
product whose features．characteristics．components．materials．or systems co咖ict with specific
requirements or provisions of this standard does not comply with this standard Revision of requirements
shall be proposed and adopted in conformance with the methods employed for development revision ana
imDlementation of this standard
2 General
2.1 Units of measurement
2.1.1 Values stated without parentheses are the requirement Values in parentheses are explanatory or
approximate information
2.2 Undated references
2.2.1 Any undated reference to a code or standard appearing in the requirements of this standard shal
be interpreted as referring to the latest edition of that code or standard
CopyrighL by the UndenEiLers LaboraLories]nc
Sun Sep 05 1029：46 2004
UL 2360-2000 history
2017UL 2360 BULLETIN-2017 UL Standard for Saftey Test Methods for Determining the Combustability Characteristics of Plastics Used in Semi-Conductor Tool Construction (COMMENTS DUE: September 11@ 2017)
1970UL 2360-2017 Test Methods for Determining the Combustibility Characteristics of Plastics Used in Semi-Conductor Tool Construction
2013UL 2360 BULLETIN-2013 UL Standard for Saftey Test Methods for Determining the Combustability Characteristics of Plastics Used in Semi-Conductor Tool Construction (COMMENTS DUE: MAY 27@ 2013)
2008UL 2360 BULLETIN-2008 UL Standard for Saftey Test Methods for Determining the Combustability Characteristics of Plastics Used in Semi-Conductor Tool Construction ALL COMMENTS DUE: MAY 19, 2008
2000UL 2360-2000 Test Methods for Determining the Combustibility Characteristics of Plastics Used in Semi-Conductor Tool Construction