This International Standard applies to interfaces between low-voltage switchgear, controlgear, and controllers (e.g. programmable controllers, personal computers, etc.).
This standard does not apply to higher level industrial communication networks that have become known as fieldbuses and are considered by IEC subcommittee 65C.
The purpose of this standard is to harmonize and define rules, components and requirements of a general nature applicable to industrial CDIs. Those features of the various CDI standards which can be considered as general have therefore been brought together in this part of IEC 62026.
For each CDI, two main documents are necessary to determine all requirements and tests:
a) this part, referred to as "part 1" in the relevant CDI parts covering the various types of CDIs;
b) the specific CDI part of the IEC 62026 series.
A specific CDI part may omit a general requirement if it is not applicable, or it may add to it if it is inadequate in the particular case, but it shall not deviate from the requirement unless there is substantial technical justification.
NOTE Product-specific requirements for products incorporating a CDI are given in the relevant product standards. These requirements apply in addition to those given in this International Standard.
IEC 62026-1:2000 history
0000 IEC 62026-1:2019 RLV
2007IEC 62026-1:2007 Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 1: General rules
2000IEC 62026-1:2000 Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 1: General rules