BS EN 10246-16:2000
Non-destructive testing of steel tubes - Automatic ultrasonic testing of the area adjacent to the weld seam of welded steel tubes for the detection of laminar imperfections
- Standard No.
- BS EN 10246-16:2000
- Release Date
- 2000
- Published By
- British Standards Institution (BSI)
- Status
- 2011-04
- Replace By
- BS EN ISO 10893-8:2011
- Latest
- BS EN ISO 10893-8:2011
- Scope
- This part of EN 10246 specifies requirements for the ultrasonic testing of the area adjacent to the weld of welded steel tubes for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures. NOTE: This inspection may alternatively, in accordance with EN 10246-15, be carried out on longitudinal edges of strip/plate (used in the manufacture of welded tubes) in the flat form prior to seam welding. Electric welded tubes may alternatively be inspected in accordance with EN 10246-14 assuming that the scanning coverage used is sufficient to detect the minimum imperfection length given in table 1. This part of EN 10246 is applicable to the inspection of welded tubes with an outside diameter greater than 30 mm. No lower limit of wall thickness is specified but see note in 4.1. European Standard EN 10246, Non-destructive testing of steel tubes, comprises the parts shown in Annex A.
BS EN 10246-16:2000 history
- 2011 BS EN ISO 10893-8:2011 Non-destructive testing of steel tubes. Automated ultrasonic testing of seamless and welded steel tubes for the detection of laminar imperfections
- 2000 BS EN 10246-16:2000 Non-destructive testing of steel tubes - Automatic ultrasonic testing of the area adjacent to the weld seam of welded steel tubes for the detection of laminar imperfections
