IEC 60349-1:1999
Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic convertor-fed alternating current motors

Standard No.

IEC 60349-1:1999

Release Date

1999

Published By

International Electrotechnical Commission (IEC)

Status

Withdraw 2010-10

Replace By

IEC 60349-1:2002

Latest

IEC 60349-1:2010

Replace

IEC 9/529/FDIS:1999 IEC 60349:1991

Scope

1 This part of IEC 60349 is applicable to rotating electrical machines, other than electronic convertor-fed alternating current motors, forming part of the equipment of electrically propelled rail and road vehicles. The vehicles may obtain power either from an external supply or from an internal source. The object of this standard is to enable the performance of a machine to be confirmed by tests and to provide a basis for assessment of its suitability for a specified duty and for comparison with other machines. NOTE 1 This standard also applies to machines installed on trailers hauled by electrically propelled vehicles. NOTE 2 The basic requirements of this standard may be applied to rotating electrical machines for special purpose vehicles such as mine locomotives, but it does not cover flameproof or other special features that may be required. NOTE 3 It is not intended that this standard should apply to machines on small road vehicles such as battery-fed delivery vehicles, works trucks, etc. Neither does it apply to minor machines such as windscreen wiper motors, etc. that may be used on all types of vehicles. NOTE 4 Industrial type machines complying with the IEC 60034 series may be suitable for certain auxiliary applications. 2 Electrical inputs or outputs of machines covered by this standard may be as follows: a) direct current (including rectified polyphase alternating current); b) pulsating current (rectified single-phase alternating current); c) unidirectional chopper-controlled current; d) single-phase alternating current; e) polyphase alternating current (in general three-phase). 3 In this standard, the electrical machines concerned are classified as follows. 3.1 Traction motors Motors for propelling rail or road vehicles. 3.2 Engine-driven main generators Generators for supplying power to traction motors on the same vehicle or train. 3.3 Main motor-generator sets Machines obtaining power from a line or battery, and supplying power to traction motors on the same vehicle or train.

IEC 60349-1:1999 history

• 2010 IEC 60349-1:2010 Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic converter-fed alternating current motors
• 1970 IEC 60349-1:1999/AMD1:2002 Amendment 1 - Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic convertor-fed alternating current motors
• 2002 IEC 60349-1:2002 Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic convertor-fed alternating current motors
• 1999 IEC 60349-1:1999 Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic convertor-fed alternating current motors

IEC 60349-1:1999 Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic convertor-fed alternating current motors has been changed from IEC 60349:1991 Electric Traction Rotating Electrical Machines for Rail and Road Vehicles (Edition 2.0).