ISO 11118:1999
Gas cylinders - Non-refillable metallic gas cylinders - Specification and test methods

Standard No.

ISO 11118:1999

Release Date

1999

Published By

International Organization for Standardization (ISO)

Status

Be replaced

Replace By

ISO 11118:2015

Latest

ISO 11118:2015/Amd 1:2019

Scope

This International Standard specifies minimum requirements for the material, design, construction and workmanship, manufacturing processes and tests at manufacture of non-refillable metallic gas cylinders of welded, brazed or seamless construction for compressed, liquefied and dissolved gases exposed to extreme worldwide ambient temperatures. NOTE The specific gases permitted in cylinders constructed to this International Standard may be limited by ISO, national requirements or international requirements. This International Standard is applicable to cylinders where: a) the maximum permissible operating pressure does not exceed 250 bar (i.e. pms ≤　250 bar); b) the product of the maximum permissible operating pressure and the water capacity does not exceed 1 000 bar.litres (i.e. pms·V ≤ 1 000 bar.l); c) where the maximum permissible operating pressure exceeds 35 bar, the water capacity does not exceed 5| (i.e. for pms > 35 bar, then V ≤ 5|). This International Standard is not applicable to cylinders exceeding these pressure and volume limits, for which reference may be made to refillable cylinder standards. This International Standard is also not applicable to cartridges/aerosol dispensers and spherical containers. note: 1) Cartridges are non-refillable containers which do not contain an integral dispensing device, have a maximum water capacity of 1 | and have a limited maximum permissible operating pressure (as defined by the country of use). Aerosol dispensers are non-refillable thin-walled containers which do contain an integral dispensing device, have a maximum water capacity of 1 | and have a limited maximum permissible operating pressure (as defined by the country of use).

ISO 11118:1999 Referenced Document

• ISO 11114-1 Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 1: Metallic materials — Amendment 1*， 2023-07-13 Update
• ISO 3166-1 Codes for the representation of names of countries and their subdivisions — Part 1: Country code*， 2020-08-25 Update
• ISO 3574:1986 Cold-reduced carbon steel sheet of commercial and drawing qualities
• ISO 3807 Gas cylinders — Acetylene cylinders — Basic requirements and type testing*， 2013-09-01 Update
• ISO 4705:1983 Refillable seamless steel gas cylinders
• ISO 4706 Gas cylinders — Refillable welded steel cylinders — Test pressure 60 bar and below*， 2023-09-20 Update
• ISO 6892 Metallic materials - Tensile testing at ambient temperature
• ISO 7866:1999 Gas cylinders - Refillable seamless aluminium alloy gas cylinders - Design, construction and testing
• ISO 9328-5 Steel flat products for pressure purposes - Technical delivery conditions - Part 5: Weldable fine grain steels, thermomechanically rolled*， 2018-02-01 Update
• ISO 9809-1:1999 Gas cylinders - Refillable seamless steel gas cylinders - Design, construction and testing - Part 1: Quenched and tempered steel cylinders with tensile strength less than 1100 MPa

ISO 11118:1999 history

• 2019 ISO 11118:2015/Amd 1:2019 Gas cylinders — Non-refillable metallic gas cylinders — Specification and test methods — Amendment 1
• 2015 ISO 11118:2015 Gas cylinders - Non-refillable metallic gas cylinders - Specification and test methods
• 1999 ISO 11118:1999 Gas cylinders - Non-refillable metallic gas cylinders - Specification and test methods