ISO 10955:1999 PDF

Scope: This International Standard specifies the characteristics, the inspection and test methods as well as the quality assurance requirements for: — end-fittings swaged on wire ropes, as specified in ISO 9737, ISO 9747, ISO 9748, ISO 9749, ISO 9759 and ISO 9760, — wire rope turnbarrel parts, as specified in ISO 9736, ISO 9738, ISO 9757, ISO 9758 and ISO 9761, and — wire rope turnbarrel assemblies (as defined in 3.1), used in aircraft controls. This International Standard is applicable to the parts cited above providing that reference is made to it in the product standard or the definition document.

ISO 10955:1999 Referenced Document

ISO 2020-1:1997 Aerospace - Preformed flexible steel wire rope for aircraft controls - Part 1: Dimensions and loads
ISO 2859-1 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection; Technical Corrigendum 1*， 2001-03-01 Update
ISO 5855-2 Aerospace - MJ threads - Part 2: Limit dimensions for bolts and nuts*， 1999-10-01 Update
ISO 8074:1985 Aerospace; Surface treatment of austenitic stainless steel parts
ISO 8785:1998 Geometrical Product Specification (GPS) - Surface imperfections - Terms, definitions and parameters
ISO 9001:1994 Quality systems - Model for quality assurance in design, development, production, installation and servicing
ISO 9002:1994 Quality systems - Model for quality assurance in production, installation and servicing
ISO 9003:1994 Quality systems - Model for quality assurance in final inspection and test
ISO 9763:1999 Aerospace - Aircraft control wire rope assemblies - Technical specification

1999 ISO 10955:1999 Aerospace - End-fittings and turnbarrels for aircraft control wire rope - Technical specification