This standard specifies methods for performing pull-off tests on single coatings or multicoat systems of paints, varnishes or Kanen products. This test method is applicable to a wide range of substrates. Different procedures are prescribed depending on whether the substrate is deformable, such as thin metal plates, plastic and wood, or rigid, such as thick concrete and metal plates. For special purposes, the test cylinder may be painted. In this case, the method of measuring the coating thickness shall be determined by agreement between the parties concerned. The test result is the minimum tension required to fail the weakest interface (interfacial failure) or weakest component (cohesive failure) of the test assembly. In addition. Adhesive/cohesive failure may occur simultaneously.