GB 17196-1997
Connecting devices--Flat quick-connect terminations for electrical copper conductors--Safety requirements (English Version)

Standard No.

GB 17196-1997

Language

Chinese, Available in English version

Release Date

1997

Published By

General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China

Status

Be replaced 2018-07

Replace By

GB/T 17196-2017

Latest

GB/T 17196-2017

Scope

This standard applies to flat quick-connect terminals, which consist of a tab in a matching socket, and are used as built-in parts or integral parts of equipment or components, or as independent units, used to press According to the manufacturer's instructions, the nominal width of the plug for connecting copper wires is 2.8mm, 4.8mm, 6.3mm or 9.5mm (0.110in, 0.187in, 0.250in or 0.375in). The copper wire connected to it can be a soft wire or a hard stranded wire with a cross-sectional area not exceeding 6mm² (AWG wire gauge number not less than 10), or a cross-sectional area not exceeding 2.5mm<上Hard single-core wire marked 2> (AWG wire gauge number not less than 14). These terminals shall have a rated voltage not exceeding 1000 V ac and a frequency not exceeding 1000 Hz, or a rated voltage not exceeding 1500 V dc; the temperature limits shall be as specified for materials used within the scope of this standard. Requirements for insulating tabs and sockets are under consideration.

GB 17196-1997 history

• 2017 GB/T 17196-2017 Connecting devices—Flat quick-connect terminations for electrical copper conductors—Safety requirements
• 1997 GB 17196-1997 Connecting devices--Flat quick-connect terminations for electrical copper conductors--Safety requirements

GB 17196-1997 Connecting devices--Flat quick-connect terminations for electrical copper conductors--Safety requirements was changed to GB/T 17196-2017 Connecting devices—Flat quick-connect terminations for electrical copper conductors—Safety requirements.