IEC 61290-2-2:1998
Optical fibre amplifiers - Basic specification - Part 2-2: Test methods for optical power parameters - Electrical spectrum analyzer

Standard No.

IEC 61290-2-2:1998

Release Date

1998

Published By

International Electrotechnical Commission (IEC)

Status

Withdraw

Latest

IEC 61290-2-2:1998

Replace By

IEC 61290-1-2:2005

Scope

This part of IEC 61290 applies to optical fibre amplifiers (OFAs) using active fibres, containing rare-earth dopants, presently commercially available. The object of this standard is to establish uniform requirements for accurate and reliable measurements, by means of the electrical spectrum analyzer test method, of the following OFA parameters, as defined in clause 3 of IEC 61291-1: a) nominal output signal power; b) large-signal output stability; c) saturation output power; d) maximum input signal power; e) maximum output signal power; f) input power range; g) output power range; h) maximum total output power. NOTE - All numerical values followed by (≠) are currently under consideration.

IEC 61290-2-2:1998 history

• 1998 IEC 61290-2-2:1998 Optical fibre amplifiers - Basic specification - Part 2-2: Test methods for optical power parameters - Electrical spectrum analyzer

IEC 61290-2-2:1998 Optical fibre amplifiers - Basic specification - Part 2-2: Test methods for optical power parameters - Electrical spectrum analyzer was changed to IEC 61290-1-2:2005 Optical amplifiers - Test methods - Part 1-2: Power and gain parameters - Electrical spectrum analyzer method.