1.1 This test method provides a means for evaluating contact compatibility between asphaltic materials. It is generally used to determine compatibility between the saturant and coating used in the manufacture of prepared roofings.2 Coating and saturant will be referred to, but comparable asphaltic materials may be tested where this test procedure seems applicable.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D1370/D1370M-12(2016) Referenced Document
ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes
ASTM D1370/D1370M-12(2016) history
2021ASTM D1370/D1370M-12(2021) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2016ASTM D1370/D1370M-12(2016) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2012ASTM D1370/D1370M-12 Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2000ASTM D1370-00(2007) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2000ASTM D1370-00 Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)