ASTM D4473-08(2021)
Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior

Standard No.

ASTM D4473-08(2021)

Release Date

2021

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D4473-08(2021)

Scope

1.1 This test method covers the use of dynamic-mechanicaloscillation instrumentation for gathering and reporting the thermal advancement of cure behavior of thermosetting resin. It may be used for determining the cure properties of both unsupported resins and resins supported on substrates subjected to various oscillatory deformations. 1.2 This test method is intended to provide a means for determining the cure behavior of supported and unsupported thermosetting resins over a range of temperatures by free vibration as well as resonant and nonresonant forced-vibration techniques, in accordance with Practice D4065. Plots of modulus, tan delta, and damping index as a function of time/temperature are indicative of the thermal advancement or cure characteristics of a resin. 1.3 This test method is valid for a wide range of frequencies, typically from 0.01 to 100 Hz. However, it is strongly recommended that low-frequency test conditions, generally below 1.5 Hz, be utilized as they generally will result in more definitive cure-behavior information. 1.4 This test method is intended for resin/substrate composites that have an uncured effective elastic modulus in shear greater than 0.5 MPa. 1.5 Apparent discrepancies may arise in results obtained under differing experimental conditions. These apparent differences from results observed in another study can usually be reconciled, without changing the observed data, by reporting in full (as described in this test method) the conditions under which the data were obtained. 1.6 Due to possible instrumentation compliance, especially in the compressive mode, the data generated may indicate relative and not necessarily absolute property values. 1.7 Test data obtained by this test method are relevant and appropriate for use in engineering design. 1.8 The values stated in SI units are to be regarded as the standard. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 5. NOTE 1—There is no known ISO equivalent to this standard. 1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D4473-08(2021) Referenced Document

• ASTM D4000 Standard Classification System for Specifying Plastic Materials*， 2023-03-15 Update
• ASTM D4065 Standard Practice for Plastics: Dynamic Mechanical Properties: Determination and Report of Procedures
• ASTM D4092 Standard Terminology: Plastics: Dynamic Mechanical Properties

ASTM D4473-08(2021) history

• 2021 ASTM D4473-08(2021) Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior
• 2008 ASTM D4473-08(2016) Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior
• 2008 ASTM D4473-08 Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior
• 2003 ASTM D4473-03 Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior
• 2001 ASTM D4473-01 Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior
• 1995 ASTM D4473-95a Standard Test Method for Plastics: Dynamic Mechanical Properties: Cure Behavior