ETSI EN 300 220-1:1997 PDF

Standard No.: ETSI EN 300 220-1:1997
Release Date: 1997
Published By: ETSI - European Telecommunications Standards Institute
Status: Be replaced 2014-04
Replace By: ETSI EN 300 220-1:2000
Latest: ETSI EN 300 220-1-2017

Scope: "The present document covers the minimum characteristics considered necessary for Short Range Devices (SRD) in order to make the best use of the available frequencies. The term ""The present document"" refers to EN 300 220-1 only. The present document contains the technical characteristics for radio equipment referencing CEPT/ERC Decisions and Recommendation CEPT ERC/Recommendation 70-03 [1]. The present document does not necessarily include all the characteristics which may be required by a user@ nor does it necessarily represent the optimum performance achievable. It is a product family standard which may be completely or partially superseded by specific standards covering specific applications. The present document applies to short range devices: - either with a Radio Frequency (RF) output connection and/or with an integral antenna; - for alarms@ identification@ telecommand@ telemetry@ etc.@ applications; - with or without speech; - operating on radio frequencies between 25 MHz and 1 000 MHz@ with power levels up to 500 mW@ radiated or conducted. The parameters in clauses 8 and 9 of the present document are considered as spectrum utilization parameters. It is intended that these parameters will be measured by an accredited test laboratory for the purpose of type testing and approval. The present document covers fixed stations@ mobile stations and portable stations. In the present document basic requirements are given for the different frequency bands@ channel separations etc.@ where appropriate. All types of modulation are covered@ in the present document@ provided the requirements of subclauses 8.5 or 8.6@ whichever is applicable@ are met. The radio equipment@ covered by the classification SRD is divided into several classes based on maximum output power (see table 1). The class designation is based on CEPT/ERC Recommendation 70-03 [1]. For non-harmonized parameters@ national regulatory conditions can apply regarding the type of modulation@ channel/frequency separations@ maximum transmitter output power/effective radiated power@ duty cycle@ equipment marking and the inclusion of an automatic transmitter shut-off facility as a condition of the issue of an individual or general licence@ or@ as a condition of use under licence exemption. The extreme temperature ranges are fixed and are given in subclause 5.4.1.2. The present document does not require measurements for radiated emissions below 25 MHz. Additional standards or specifications can be required for equipment such as that intended for connection to the Public Switched Telephone Network (PSTN)."

ETSI EN 300 220-1:1997 history

2017 ETSI EN 300 220-1-2017 Short Range Devices (SRD) operating in the frequency range 25 MHz to 1 000 MHz; Part 1: Technical characteristics and methods of measurement (V3.1.1)
2016 ETSI EN 300 220-1:2016 Short Range Devices (SRD) operating in the frequency range 25 MHz to 1 000 MHz; Part 1: Technical characteristics and methods of measurement (V3.1.0)
2012 ETSI EN 300 220-1:2012 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2010 ETSI EN 300 220-1:2010 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2009 ETSI EN 300 220-1:2009 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2008 ETSI EN 300 220-1:2008 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2006 ETSI EN 300 220-1:2006 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2005 ETSI EN 300 220-1:2005 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V2
2000 ETSI EN 300 220-1:2000 Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods (V1
1997 ETSI EN 300 220-1:1997 Electromagnetic Compability and Radio Spectrum Matters (ERM); Short Range Devices; Technical Characteristics and Test Methods for Radio Equipment to be Used in the 25 MHz to 1 000 MHz Frequency Range with Power Levels Ranging up to 500 mW; Part 1: Paramet

ETSI EN 300 220-1:1997Electromagnetic Compability and Radio Spectrum Matters (ERM); Short Range Devices; Technical Characteristics and Test Methods for Radio Equipment to be Used in the 25 MHz to 1 000 MHz Frequency Range with Power Levels Ranging up to 500 mW; Part 1: Paramet

ETSI EN 300 220-1:1997 history

ETSI EN 300 220-1:1997
Electromagnetic Compability and Radio Spectrum Matters (ERM); Short Range Devices; Technical Characteristics and Test Methods for Radio Equipment to be Used in the 25 MHz to 1 000 MHz Frequency Range with Power Levels Ranging up to 500 mW; Part 1: Paramet