ASTM D1635/D1635M-19
Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading 

Standard No.

ASTM D1635/D1635M-19

Release Date

2019

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D1635/D1635M-19

Scope

1.1 This test method covers the determination of the flexural strength of soil-cement by the use of a simple beam with third-point loading. NOTE 1—For methods of molding soil-cement specimens, see Practice D1632. 1.2 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. The SI units are presented in brackets. 1.2.1 The gravitational system of inch-pound units is used when dealing with inchpound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The rationalized slug unit is not given, unless dynamic (F = ma) calculations are involved. 1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026. 1.3.1 The procedures used to specify how data are collected/ recorded or calculated in the standard are regarded as industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1635/D1635M-19 Referenced Document

• ASTM D1632 Standard Practice for Making and Curing Soil-Cement Compression and Flexure Test Specimens in the Laboratory
• ASTM D2216 Standard Test Method for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass
• ASTM D3740 Standard Practice for Minimum Requirements for Agencies Engaged in the Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
• ASTM D6026 Standard Practice for Using Significant Digits in Geotechnical Data
• ASTM D653 Standard Terminology Relating to Soil, Rock, and Contained Fluids
• ASTM E4 Standard Practices for Force Verification of Testing Machines

ASTM D1635/D1635M-19 history

• 2019 ASTM D1635/D1635M-19 Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading 
• 2012 ASTM D1635/D1635M-12 Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading
• 2000 ASTM D1635-00(2006) Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading
• 2000 ASTM D1635-00 Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading