ASTM B680-80(2019) PDF

Scope: 1.1 This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution. 1.2 This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important. 1.3 This test method is not applicable to: 1.3.1 Hard coatings, which normally are not sealed. 1.3.2 Anodic coatings that have been sealed only in dichromate solutions. 1.3.3 Anodic coatings that have undergone a treatment to render them hydrophobic. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B680-80(2019) Referenced Document

ASTM B137 Standard Test Method for Measurement of Coating Mass Per Unit Area on Anodically Coated Aluminum*， 2024-04-22 Update
ASTM D1193 Standard Specification for Reagent Water

2019 ASTM B680-80(2019) Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
1980 ASTM B680-80(2014) Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
1980 ASTM B680-80(2009) Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
1980 ASTM B680-80(2004) Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
1980 ASTM B680-80(2000) Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution