1.1 This practice applies to all coatings cured by ultraviolet energy.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D3732-82(2017) Referenced Document
ASTM D1474 Standard Test Methods for Indentation Hardness of Organic Coatings
ASTM D2197 Standard Test Method for Adhesion of Organic Coatings by Scrape Adhesion
ASTM D2336 Standard Guide for Specifying Factory Applied Wood Coatings
ASTM D2793 Standard Test Method for Block Resistance of Organic Coatings on Wood Panel Substrates*, 2024-02-01 Update
ASTM D2794 Standard Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)*, 2024-01-25 Update
ASTM D3023 Standard Practice for Determination of Resistance of Factory-Applied Coatings on Wood Products to Stains and Reagents*, 2024-02-01 Update